PanaVise InDash Car Mount for 2008 2009 Saturn Astra

The Panavise InDash Custom Mount eliminates exposed holes in vehicle for clean, easy, and nearly invisible phone mount installation. Proudly made in the USA from the highest quality heavy gauge steel, this Panavise Custom Indash Mount has been fitted and produced specifically for your car to provide the utmost convenience and practicality. Complete mounting instructions are included with your purchase and are also available below.

Mounting Location: Right side of radio

Tools Required: (1set) 2-Radio Removal Keys, Metra#86-3528, Soft Cloth, T-15 Torx Driver, Marking tool, Phillips Screwdriver

Hardware Included: (2)-A-#8x 9/16" Needle Pt. Screw; (2)-O-8-32 Acorn Nuts

Mounting Instructions:

Step# 1: With Dash tool set remove the Radio, disconnect plugs and set aside.

Step# 02: With fingers, lift up on the clips on the top of the climate control. Pull out the climate control, disconnect plugs and set aside.

Step# 03: Use the T-15 Torx driver to remove (2) screws located in the lower right and Left sides of the climate control cavity that hold the bezel around the radio and climate control and include the air vents. Start at the bottom of the bezel, pull to release (2) clips along side of the radio, (plastic). And release (2) more metal clips to right and left of air vents.

Step# 04: Place bottom part of InDash by PanaVise Mount into slot on right side of radio bezel 1/2 down so the mount screw slots sit onto the dash piece behind the bezel. Place bezel back in place. With Marking tool (awl, scribe) make a line along the back and edges of the mount to show where bottom piece sits to install screws.

Step# 05: Remove the bezel, align the bottom part of mount with marks, install the (2) screws. Carefully replace the bezel. The mount should sit against the side of the bezel radio cavity. Replace the climate control, and radio.

Compatible With:

• 2008-2009 Saturn Astra